how to configure wan load balancing on fortigate 80c

There is no requirement that the interfaces be those labeled on the hardware as WAN interfaces.The interfaces in the virtual WAN link can be disabled if necessary if work needs to be done on an interface without interfering with the performance of the link.While most of the load balancing algorithms are based on equal distribution or weighted distribution, spill over does rely on which interface is first in the sequence, so this should be kept in mind when adding the interfaces.As interfaces are added to the “wan-load-balance” interface, they are added into the calculations that comprise the various algorithms used to do the load balancing.

The basis for the configuration of the virtual WAN link are the interfaces that comprise it. The 5.2 L i n k Health Monitor definitions are now only available from the CLI. WAN Load Balancing should be used instead of the 5.2 E C M P Load Balancing Method settings. There is now a WA N Load Balancing feature located in the N e t w o r k section of the GUI (“WAN LLB”).Īs part of the new WAN Load Balancing feature, the FortiOS 5.2 R ou t e r > Static > Settings GUI page has been removed. Often, it can be just as important for an organizations members to be able to access the Internet as it is for the denizens of the Internet to access the Web facing resources. Have it configured so that the process of balancing the workload is automatic. Expand the capacity of the resources to handle the required workload.ģ. Reduce the places in the work flow where a single point of failure can bring the process to a halt.Ģ.

In the same way that incoming traffic can be load balanced, outgoing or WAN traffic can also be load balanced and for the same three reasons.ġ.

How to configure wan load balancing on fortigate 80c